Configuring Multicast Vrfs - Cisco Catalyst 9500 series Configuration Manual

Configuring Multicast VRFs

Step 2
Step 3
Step 4
Step 5
Step 6
Configuring Multicast VRFs
For complete syntax and usage information for the commands, see the switch command reference for this
release and the Cisco IOS IP Multicast Command Reference.
For more information about configuring a multicast within a Multi-VRF CE, see the IP Routing:
Protocol-Independent Configuration Guide, Cisco IOS Release 15S.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
170
Command or Action
ip ftp source-interface interface-type
interface-number
Example:
Device(config)# ip ftp source-interface
gigabitethernet 1/0/2
end
Example:
Device(config)#end
configure terminal
Example:
Device# configure terminal
ip tftp source-interface interface-type
interface-number
Example:
Device(config)# ip tftp source-interface
gigabitethernet 1/0/2
end
Example:
Device(config)# end
Configuring IP Unicast Routing
Purpose
Specifies the source IP address for FTP
connections.
Returns to privileged EXEC mode.
Enters global configuration mode.
Specifies the source IP address for TFTP
connections.
Returns to privileged EXEC mode.