Cisco Catalyst 9500 series Configuration Manual page 133

Configuring IP Unicast Routing
Table 14: Default BGP Configuration
Feature
Aggregate address
AS path access list
Auto summary
Best path
BGP community list
BGP confederation
identifier/peers
BGP Fast external fallover
BGP local preference
BGP network
BGP route dampening
BGP router ID
Default information originate
(protocol or network
redistribution)
Default metric
Default Setting
Disabled: None defined.
None defined.
Disabled.
• The router considers as-path in choosing a route and does not compare
similar routes from external BGP peers.
• Compare router ID: Disabled.
• Number: None defined. When you permit a value for the community
number, the list defaults to an implicit deny for everything else that
has not been permitted.
• Format: Cisco default format (32-bit number).
• Identifier: None configured.
• Peers: None identified.
Enabled.
100. The range is 0 to 4294967295 with the higher value preferred.
None specified; no backdoor route advertised.
Disabled by default. When enabled:
• Half-life is 15 minutes.
• Re-use is 750 (10-second increments).
• Suppress is 2000 (10-second increments).
• Max-suppress-time is 4 times half-life; 60 minutes.
The IP address of a loopback interface if one is configured or the highest
IP address configured for a physical interface on the router.
Disabled.
Built-in, automatic metric translations.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Default BGP Configuration
123