Cisco Catalyst 9500 series Configuration Manual page 177

Configuring IP Unicast Routing
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Command or Action
configure terminal
Example:
Device# configure terminal
interface interface-id
Example:
Device(config)#
interface gigabitethernet 1/0/1
no switchport
Example:
Device(config-if)# no switchport
ip vrf forwarding vrf-name
Example:
Device(config-if)# ip vrf forwarding vpn2
ip address ip-address
Example:
Device(config-if)# ip address 10.1.5.1
ip verify unicast reverse-path
Example:
Device(config-if)# ip verify unicast
reverse-path
end
Example:
Device(config-if)# end
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Configuring VRF-Aware Services
Purpose
Enters the global configuration mode.
Enters interface configuration mode, and
specifies the Layer 3 interface to configure.
Removes the interface from Layer 2
configuration mode if it is a physical
interface.
Configures VRF on the interface.
Enters the IP address for the interface.
Enables uRPF on the interface.
Returns to privileged EXEC mode.
167