Including A Bordering Pim Dense-Mode Region In Msdp - Cisco Catalyst 9500 series Configuration Manual

Including a Bordering PIM Dense-Mode Region in MSDP

Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Including a Bordering PIM Dense-Mode Region in MSDP
You can configure MSDP on a Device that borders a PIM sparse-mode region with a dense-mode region. By
default, active sources in the dense-mode region do not participate in MSDP.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
44
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
ip msdp shutdown {peer-name | peer
address}
Example:
Device(config)# ip msdp shutdown
switch.cisco.com
end
Example:
Device(config)# end
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Enters the global configuration mode.
Shuts down the specified MSDP peer without
losing configuration information.
For peer-name | peer address, enter the IP
address or name of the MSDP peer to shut
down.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the
configuration file.
Configuring MSDP