Configuring Basic Eigrp Parameters - Cisco Catalyst 9500 series Configuration Manual

Configuring IP Unicast Routing
Feature
IP hold-time
IP split-horizon
IP summary address
Metric weights
Network
Nonstop Forwarding (NSF) Awareness
NSF capability
Offset-list
Router EIGRP
Set metric
Traffic-share
Variance

Configuring Basic EIGRP Parameters

Before You Begin
Procedure
Step 1
Command or Action
configure terminal
Example:
Device# configure terminal
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Default Setting
For low-speed NBMA networks: 180 seconds; all other networks:
15 seconds.
Enabled.
No summary aggregate addresses are predefined.
tos: 0; k1 and k3: 1; k2, k4, and k5: 0
None specified.
Enabled for IPv4 on switches running the Network Advantage
license. Allows Layer 3 switches to continue forwarding packets
from a neighboring NSF-capable router during hardware or
software changes.
Disabled.
Note The Device supports EIGRP NSF-capable routing for
IPv4.
Disabled.
Disabled.
No metric set in the route map.
Distributed proportionately to the ratios of the metrics.
1 (equal-cost load-balancing).
Purpose
Enters the global configuration mode.
Configuring Basic EIGRP Parameters
109