Configuring Other Ospf Parameters - Cisco Catalyst 9500 series Configuration Manual

Configuring IP Unicast Routing
Step 11

Configuring Other OSPF Parameters

Procedure
Step 1
Step 2
Step 3
Step 4
Command or Action
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
configure terminal
Example:
Device# configure terminal
router ospf process-id
Example:
Device(config)# router ospf 10
summary-address address mask
Example:
Device(config)# summary-address
10.1.1.1 255.255.255.0
area area-id virtual-link router-id
[hello-interval seconds] [retransmit-interval
seconds] [trans] [[authentication-key key] |
message-digest-key keyid md5 key]]
Example:
Device(config)# area 2 virtual-link
192.168.255.1 hello-interval 5
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Configuring Other OSPF Parameters
Purpose
(Optional) Saves your entries in the configuration file.
Purpose
Enters the global configuration mode.
Enables OSPF routing, and enter router
configuration mode.
(Optional) Specifies an address and IP subnet
mask for redistributed routes so that only one
summary route is advertised.
(Optional) Establishes a virtual link and set its
parameters.
99