How To Configure Ip Unicast Routing - Cisco Catalyst 9500 series Configuration Manual

How to Configure IP Unicast Routing

Table 7: Commands to Display Caches, Tables, and Databases
show arp
show hosts
show ip aliases
show ip arp
show ip interface [interface-id]
show ip irdp
show ip masks address
show ip redirects
show ip route [address [mask]] |
[protocol]
show ip route summary
How to Configure IP Unicast Routing
Enabling IP Unicast Routing
By default, the Device is in Layer 2 switching mode and IP routing is disabled. To use the Layer 3 capabilities
of the Device, you must enable IP routing.
Procedure
Step 1
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
78
Displays the entries in the ARP table.
Displays the default domain name, style of lookup service, name
server hosts, and the cached list of hostnames and addresses.
Displays IP addresses mapped to TCP ports (aliases).
Displays the IP ARP cache.
Displays the IP status of interfaces.
Displays IRDP values.
Displays the masks used for network addresses and the number of
subnets using each mask.
Displays the address of a default gateway.
Displays the current state of the routing table.
Displays the current state of the routing table in summary form.
Command or Action
enable
Example:
Device> enable
Configuring IP Unicast Routing
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.