Controlling Source Information That Your Switch Originates - Cisco Catalyst 9500 series Configuration Manual

Controlling Source Information that Your Switch Originates

Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Controlling Source Information that Your Switch Originates
You can control the multicast source information that originates with your Device:
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
32
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
ip msdp sa-request {ip-address | name}
Example:
Device(config)# ip msdp sa-request
171.69.1.1
end
Example:
Device(config)# end
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Purpose
Enables privileged EXEC mode. Enter your password
if prompted.
Enters the global configuration mode.
Configure the Device to send SA request messages
to the specified MSDP peer.
For ip-address | name, enter the IP address or name
of the MSDP peer from which the local Device
requests SA messages when a new member for a
group becomes active.
Repeat the command for each MSDP peer that you
want to supply with SA messages.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration
file.
Configuring MSDP