Cisco Catalyst 9500 series Configuration Manual page 93

Configuring IP Unicast Routing
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Command or Action
offset-list [access-list number |
name] {in | out} offset [type
number]
Example:
Device(config)# offset-list
103 in 10
timers basic update invalid
holddown flush
Example:
Device(config)# timers basic
45 360 400 300
version {1 | 2}
Example:
Device(config)# version 2
no auto summary
Example:
Device(config)# no auto
summary
no validate-update-source
Example:
Device(config)# no
validdate-update-source
output-delay delay
Example:
Device(config)# output-delay
8
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Configuring Basic RIP Parameters
Purpose
(Optional) Applies an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through RIP.
You can limit the offset list with an access list or an interface.
(Optional) Adjusts routing protocol timers. Valid ranges for
all timers are 0 to 4294967295 seconds.
• update—The time between sending routing updates.
The default is 30 seconds.
• invalid—The timer after which a route is declared
invalid. The default is 180 seconds.
• holddown—The time before a route is removed from
the routing table. The default is 180 seconds.
• flush—The amount of time for which routing updates
are postponed. The default is 240 seconds.
(Optional) Configures the switch to receive and send only
RIP Version 1 or RIP Version 2 packets. By default, the switch
receives Version 1 and 2 but sends only Version 1. You can
also use the interface commands ip rip {send | receive}
version 1 | 2 | 1 2} to control what versions are used for
sending and receiving on interfaces.
(Optional) Disables automatic summarization. By default, the
switch summarizes subprefixes when crossing classful
network boundaries. Disable summarization (RIP Version 2
only) to advertise subnet and host routing information to
classful network boundaries.
(Optional) Disables validation of the source IP address of
incoming RIP routing updates. By default, the switch validates
the source IP address of incoming RIP routing updates and
discards the update if the source address is not valid. Under
normal circumstances, disabling this feature is not
recommended. However, if you have a router that is
off-network and you want to receive its updates, you can use
this command.
(Optional) Adds interpacket delay for RIP updates sent. By
default, packets in a multiple-packet RIP update have no delay
added between packets. If you are sending packets to a
lower-speed device, you can add an interpacket delay in the
range of 8 to 50 milliseconds.
83