Forwarding Udp Broadcast Packets And Protocols - Cisco Catalyst 9500 series Configuration Manual

Configuring IP Unicast Routing
Step 7
Step 8
Step 9
Step 10

Forwarding UDP Broadcast Packets and Protocols

If you do not specify any UDP ports when you configure the forwarding of UDP broadcasts, you are configuring
the router to act as a BOOTP forwarding agent. BOOTP packets carry DHCP information.
Procedure
Step 1
Step 2
Command or Action
end
Example:
Device(config)# end
show ip interface [interface-id]
Example:
Device# show ip interface
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Configuring Broadcast Packet Handling
Purpose
Returns to privileged EXEC mode.
Verifies the configuration on the interface or all
interfaces
Verifies your entries.
(Optional) Saves your entries in the configuration
file.
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Enters the global configuration mode.
73