Configuring Basic Eigrp Parameters - Cisco WS-C3560-48PS-S Software Configuration Manual

Chapter 30 Configuring IP Unicast Routing
Table 30-8 Default EIGRP Configuration (continued)
Feature
Distance
EIGRP log-neighbor changes
IP authentication key-chain
IP authentication mode
IP bandwidth-percent
IP hello interval
IP hold-time
IP split-horizon
IP summary address
Metric weights
Network
Offset-list
Router EIGRP
Set metric
Traffic-share
Variance
To create an EIGRP routing process, you must enable EIGRP and associate networks. EIGRP sends
updates to the interfaces in the specified networks. If you do not specify an interface network, it is not
advertised in any EIGRP update.
Note If you have routers on your network that are configured for IGRP, and you want to change to EIGRP, you
must designate transition routers that have both IGRP and EIGRP configured. In these cases, perform
Steps 1 through 3 in the next section and also see the
must use the same AS number for routes to be automatically redistributed.

Configuring Basic EIGRP Parameters

Beginning in privileged EXEC mode, follow these steps to configure EIGRP. Configuring the routing
process is required; other steps are optional:
Command
Step 1
configure terminal
Step 2 router eigrp autonomous-system
78-16156-01
Default Setting
Internal distance: 90.
External distance: 170.
Disabled. No adjacency changes logged.
No authentication provided.
No authentication provided.
50 percent.
For low-speed nonbroadcast multiaccess (NBMA) networks:
60 seconds; all other networks: 5 seconds.
For low-speed NBMA networks: 180 seconds; all other networks:
15 seconds.
Enabled.
No summary aggregate addresses are predefined.
tos: 0; k1 and k3: 1; k2, k4, and k5: 0
None specified.
Disabled.
Disabled.
No metric set in the route map.
Distributed proportionately to the ratios of the metrics.
1 (equal-cost load balancing).
"Configuring IGRP" section on page
Purpose
Enter global configuration mode.
Enable an EIGRP routing process, and enter router configuration
mode. The AS number identifies the routes to other EIGRP routers
and is used to tag routing information.
Catalyst 3560 Switch Software Configuration Guide
Configuring EIGRP
30-23. You
30-39