Table of Contents
Advertisement
CHAPTER
28
WALL MOUNTING
The AutoRAE 2 can be used on a flat surface, or it can be mounted on a wall. This requires
drilling holes into the wall and inserting screws to hold the AutoRAE 2.
Note: Handheld PID Cradles cannot be wall-mounted.
Important! Make sure the wall is strong enough to support the weight of the AutoRAE 2
Controller and attached AutoRAE 2 cradles. If necessary, mount a piece of plywood or use other
reinforcement for the wall.
Use a pair of slotted TS35 DIN rails (35mm high x 7.5mm deep) cut to slightly longer than the
length of the assembled system and attach to a strong wall or other rigid surface using low-
profile screws. Make sure the center-to-center spacing of the slotted rails is 135 mm.
Once the rails have been firmly fastened to the wall, slide the AutoRAE 2 Controller from the left
side onto the rails. Then slide an AutoRAE 2 Cradle onto the rails from the right side. Make sure
that the last AutoRAE 2 Cradle has the Terminal Adapter from the AutoRAE 2 Controller
attached.
AutoRAE 2
129
User Manual
Advertisement
Table of Contents
