Table of Contents
Advertisement
name of a single device, groupname is the name of a user-defined device group,
and
all
Command:
erase startup-configuration
on <devname|groupname|all> erase startup-configuration
Remote, Serial, Telnet
Availability:
Description:
Erases the startup configuration stored in flash on the device. You must specify a
device unless only one device is attached. When using remote configuration, use
the
on
devname is the name of a single device, groupname is the name of a user-defined
device group, and
Command:
quick-start
on <devname|groupname|all> quick-start
Remote, Serial, Telnet
Availability:
Description:
Runs the QuickStart wizard for the device. You must specify a device unless only
one device is attached. When using remote configuration, use the
command to specify the target(s) of the command, where devname is the name
of a single device, groupname is the name of a user-defined device group, and
represents all appropriate devices.
Command:
reload
on <devname|groupname|all> reload
Remote, Serial, Telnet
Availability:
Description:
Reboots the device. The device resumes operation using the startup configuration
stored in the flash memory. You are prompted to confirm restarting the device.
When using remote configuration, use the
target(s) of the command, where devname is the name of a single device,
groupname is the name of a user-defined device group, and
appropriate devices.
Note:
Command:
show access-list [<listid>]
on <devname|groupname|all> show access-list [<listid>]
Availability:
Remote, Serial, Telnet
Description:
Displays the specified access list, where listid is the valid access list id number
defined on the device. If you do not specify an access list id, information for all
access-lists is displayed. When using remote configuration, use the
command to specify the target(s) of the command, where devname is the name
of a single device, groupname is the name of a user-defined device group, and
represents all appropriate devices.
represents all appropriate devices.
form of the command to specify the target(s) of the command, where
represents all appropriate devices.
all
You are not prompted to verify rebooting devices on a device-by-
device basis.
Appendix C Command Summary
form of the command to specify the
on
all
form of the
on
all
represents all
form of the
on
all
Page 97
Advertisement
Table of Contents
