Table of Contents
Advertisement
Privileged Command Set
Use Privileged mode commands to view and edit device-specific configuration information.
Enter Privileged mode for a device by using the enable command. All Non-Privileged
commands are also available.
Command:
Availability:
Description:
Command:
Availability:
Description:
Command:
Availability:
Description:
Command:
Availability:
Description:
Command:
Availability:
Description:
Page 94 SSL-IA/SSL-R User's Guide
clear interface statistics
on <devname|groupname|all> clear interface statistics
Remote, Serial, Telnet
Resets all interface statistics for a single device. When using remote configuration,
use the
form of the command to specify the target(s) of the command, where
on
devname is the name of a single device, groupname is the name of a user-defined
device group, and
all
clear ip routes
on <devname|groupname|all> clear ip routes
Remote, Serial, Telnet
Clears the IP routing table on a single device. When using remote configuration,
use the
form of the command to specify the target(s) of the command, where
on
devname is the name of a single device, groupname is the name of a user-defined
device group, and
all
clear ip statistics
on <devname|groupname|all> clear ip statistics
Remote, Serial, Telnet
Resets all IP statistics for a single device. When using remote configuration, use
the
form of the command to specify the target(s) of the command, where
on
devname is the name of a single device, groupname is the name of a user-defined
device group, and
all
clear messages
on <devname|groupname|all> clear messages
Remote, Serial, Telnet
Empties the diagnostic message buffer for a single device. When using remote
configuration, use the
on
command, where devname is the name of a single device, groupname is the name
of a user-defined device group, and
clear ssl statistics
on <devname|groupname|all> clear ssl statistics
Remote, Serial, Telnet
Resets all SSL statistics for a single device. When using remote configuration, use
the
form of the command to specify the target(s) of the command, where
on
devname is the name of a single device, groupname is the name of a user-defined
device group, and
all
represents all appropriate devices.
represents all appropriate devices.
represents all appropriate devices.
form of the command to specify the target(s) of the
represents all appropriate devices.
all
represents all appropriate devices.
Advertisement
Table of Contents
