Table of Contents
Advertisement
2
Attach the configuration manager (remote only) and enter Privileged and
Configuration modes.
inxcfg> enable
inxcfg> configure
3
Enter SNMP data and enable SNMP. Access-list 1 has already been created. (See
Chapter C Command Summary for information for using the access-list
command.) Return to Privileged mode.
(config[myDevice])> snmp enable
(config[myDevice])> snmp access-list 1
(config[myDevice])> snmp location "Main Office"
(config[myDevice])> snmp contact "Administrator"
(config[myDevice])> snmp default community ITS_Office
(config[myDevice])> snmp trap-host v1 10.1.2.4
(config[myDevice])> snmp trap-type generic
(config[myDevice])> end
inxcfg>
4
Save the configuration to flash memory. If not saved, the configuration is lost
during a power cycle or if the reload command is used.
inxcfg> write flash
inxcfg>
Supporting RIP
SonicWALL SSL devices support Routing Information Protocol (RIP) versions 1 and 2. This
example demonstrates how to enable RIP version 1 packet usage.
EXAMPLE: Configuring RIP
1
Initiate a management session as described previously.
2
Attach the configuration manager (remote only) and enter Privileged and
Configuration modes.
inxcfg> enable
inxcfg> configure
3
Enable reception and processing of RIP version 1 packets. Then return to Privileged
mode.
(config[myDevice])> rip v1
(config[myDevice])> end
inxcfg>
Chapter 5 Configuration Manager
Page 59
Advertisement
Table of Contents
