Table of Contents
Advertisement
below create a device group named myGroup and add three devices to it and display the
contents of the group.
inxcfg> group myGroup create
(group[myGroup])> device sslDev1
(group[myGroup])> device sslDev2
(group[myGroup])> device myDevice
(group[myGroup])> info
group name: myGroup
number of devices: 3
device: sslDev1
device: sslDev2
device: myDevice
(group[myGroup])>
To remove a device from the group, use the no form of the command:
(group[myGroup])> no device sslDev2
Enter end to return to exit group configuration mode. To send commands to every device
in the group, use the on prefix. Enter this command to attach to all devices in the group.
on myGroup attach
You can simply command entry for this group further by setting the on command to address
the group myGroup by default.
set on-prefix myGroup
After entering this command, you do not need to use the on prefix when addressing the
default target. For example, the on myGroup attach command becomes attach You can still
address another group instead of the default; simply specify its name following the on
prefix. Change the on prefix target by re-entering the command, identifying the new group.
View the on prefix target by entering show profile.
Note:
Individual devices can also be set as the
without the
on
set on-prefix
Remote Configuration Caching
The remote configuration manager caches some management session information. Some
changes made during a configuration session may not be displayed. Additionally,
configuration changes from multiple concurrent configuration sessions may not be
reflected in status and configuration displays. To obtain the most current configuration
data, exit the configuration manager and launch the application again.
prefix defaults to the group or device specified by the
command.
Appendix C Command Summary
prefix default target. Any command
on
Page 81
Advertisement
Table of Contents
