Command:
[no] syslog <ipaddr>
Remote, Serial, Telnet
Availability:
Adds the specified IP address to the syslog list for the device, where ipaddr is the
Description:
specified IP address. Using the
syslog list of the current device. Up to four IP addresses can be specified. Syslog
messages are sent to all hosts at the IP addresses in this list.
Command:
[no] telnet access-list <listid>
Remote, Serial, Telnet
Availability:
Specifies the access list to use for telnet management requests, where listid is the
Description:
access list identifier. Use the
access lists using the
Command:
[no] telnet enable
Remote, Serial, Telnet
Availability:
Description:
Enables management access via a telnet connection. Use the
command to disable telnet management access.
Command:
timezone <zone>
Serial, Telnet
Availability:
Specifies the time zone of the device's location, where zone is the time zone.
Description:
Command:
[no] web-mgmt access-list <listid>
Availability:
Remote, Serial, Telnet
Description:
Specifies the access list to use for browser-based (GUI) management requests,
where listid is the access list identifier. Use the
assignment. Create access lists using the
Command:
[no] web-mgmt enable
Availability:
Remote, Serial, Telnet
Description:
Enables management access via the GUI. Use the
disable web management access.
flag removes the specified IP address from the
no
flag to clear the access list assignment. Create
no
command.
access-list
access-list
Appendix C Command Summary
form of the
no
flag to clear the access list
no
command.
form of the command to
no
Page 107