Table of Contents
Advertisement
When prompted to supply a file name during a telnet management session, you
Note:
must supply it as a URL in the form of HOST/PATH/FILENAME using the http://,
https://, ftp://, or tftp:// prefix.
Remote Configuration Manager Application
Use the instructions below appropriate for the configuring computer's operating system.
Linux. Enter inxcfg at a Linux shell prompt.
Solaris. Enter inxcfg at a Unix shell prompt.
Windows NT and Windows 2000 Software. To start the configuration manager, use
the Start menu and point to Programs>SonicWALL Corporation and click
SonicWALL Configuration Manager, or double-click the shortcut on the desktop.
Starting the QuickStart Wizard
Follow the instructions below appropriate to the management session you have initiated.
Using a Serial or Telnet Connection
After initiating a management session as described previously, start the QuickStart wizard
via a serial or telnet connection by entering the following commands:
enable
quick-start
If you are using a telnet connection, go on to "Following the QuickStart Wizard", below.
If you are using a serial connection and the device has not been assigned an IP address,
you are prompted to assign a hostname and IP address before beginning the QuickStart
configuration process.
An ip address is not currently assigned to this device.
Enter the hostname for this device:
The hostname is a user-specified device name. In this example, we use the name
myDevice . When prompted for them, enter the IP address, netmask, and default gateway
for the device. You are prompted to accept the information before continuing with
configuration.
The following configuration will be saved to the device.
Hostname
Ip address
Netmask
Default gateway addr
Is the above information correct? (y/n):
Page 36 SSL-IA/SSL-R User's Guide
: myDevice
: 10.1.11.100
: 255.255.255.0
: 10.1.11.10
Advertisement
Table of Contents
