Table of Contents
Advertisement
If the information is correct, type y. The logical secure server you have configured is
created. If you type n, the server configuration process restarts using the current secure
server.
Would you like to use the QuickStart wizard to create another ssl-server? (y/n):
Type y to begin the server configuration process again with a new server. Type n to set a
configuration (enable) password for the device.
Would you like to set a password to protect configuration of the SSL-R? (y/n):
Type y, and enter a password. Re-enter it to confirm.
You must set a configuration password for the device to ensure its security. The password
you enter is not displayed.
Would you like to set a name for this device? (y/n/q):
Type y, and enter a name for the SSL appliance.
A default gateway is needed to connect outside of your local subnet.
Would you like to set a default gateway for this device? (y/n/q): y
Enter a default gateway for this device:
A default gateway is needed for the device to connect outside of the local subnet. Type y,
and enter the IP address at the prompt.
A summary screen shows information about the device, keys, certificates, security policies,
and the logical secure servers configured on it.
SSL-IA myDevice
Keys
-----------------------------------
Name
-----------------------------------
default
default-512
default-1024
Certificates
----------------------------------------------------------
Name
----------------------------------------------------------
default
default-512
default-1024
Page 42 SSL-IA/SSL-R User's Guide
SETUP CONFIGURATION PASSWORD PROTECTION
Id RC
V
1
0
Y
2
0
Y
3
0
Y
Id
RCCG
RCPS
V
1
0
0
Y
2
0
1
Y
3
0
0
Y
Advertisement
Table of Contents
