Table of Contents
Advertisement
Top Level Command Set
The Top Level command set consists of non-privileged and privileged commands. These
commands are used to view and clear statistics and device status, set terminal
configuration, enter configuration modes, manage hardware, and exit the configuration
manager.
Non-Privileged Command Set
The Non-Privileged command set consists of the lowest level commands having the least
impact on configuration and security of the devices.
Command:
Availability:
Description:
Command:
Availability:
Description:
Command:
Availability:
Description:
Page 82 SSL-IA/SSL-R User's Guide
[no] attach
on <devname|groupname|all> [no] attach
Remote
Instructs the configuration manager to attach the single remote device. Use the
flag to detach the configuration manager a single attached device. If an access-
level password has been defined, you must enter it when prompted before the
configuration manager will attach to the device(s). If a shared secret passphrase
has been assigned as part of remote management encryption, you are prompted
for it. If more than one device is valid for this command, use the
command to specify the device(s) to attach to or detach from (using the
of the command), where devname is the name of an individual device, groupname
is the name of a user-defined group, and
If you have forgotten the device's access password, see Appliance
Note:
Factory Default Reset Password on page 77.
[no] attach ip <ipaddr> [port <portid>]
Remote
Instructs the configuration manager to attach a non-attached remote device,
optionally using an alternate remote management port, where ipaddr is the IP
address of the device. Use the
use for attaching to the device, where portid is the server port number. The
remote-management port
change the management port from the default. If a shared secret passphrase has
been assigned as part of remote management encryption, you are prompted for it.
Use the
flag to detach the configuration manager from the specified device. If
no
an access-level password has been defined, you must enter it when prompted
before the configuration manager can attach to the device.
Note:
If you have forgotten the device's access password, see Appliance
Factory Default Reset Password on page 77.
clear screen
Remote, Serial, Telnet
Clears the display, leaving only one prompt line.
represents all appropriate devices.
all
option to specify a TCP/UDP service port to
port
command must have been used on the device to
no
form of the
on
form
no
Advertisement
Table of Contents
