Table of Contents
Advertisement
Command:
cls
Remote, Serial, Telnet
Availability:
Description:
Clears the display, leaving only one prompt line.
Command:
discover [port <portid>]
Remote
Availability:
Description:
Checks the network for new remote devices. Use the port option to specify a TCP
service port to search for devices when using an alternate remote management
port, where portid is the port number.
Command:
[no] enable
on <devname|groupname|all> [on] enable
Remote, Serial, Telnet
Availability:
Description:
When using serial or telnet management, enters Privileged mode for the device. If
an enable-level password has been defined, you must enter it when prompted.
When using remote management, enters Privileged mode for a single, attached
device. If more than one device is valid for this command, use the
command to specify the device(s) to enable, where devname is the name of an
individual device, groupname is the name of a user-defined group, and
represents all appropriate devices. Using the no form of this command leaves
Privileged mode.
Note:
Command:
exit
Availability:
Remote, Serial, Telnet
Description:
When executed from the remote configuration manager, closes the configurtaion
manager. When executed from a serial connection, does not close the connection.
If an access password has been configured, you are prompted for it. When
executed from telnet, closes the telnet connection.
Command:
[no] group <groupname> [create]
Availability:
Remote
Description:
Creates or configures the specified user-defined group, where groupname is the
name of the group. Use the
Group Configuration mode for it. Use the
specified group.
Command:
help [command]
Availability:
Remote, Serial, Telnet
Description:
Displays information for a specific command, where command is the name of the
command. If no command is specified, help information is displayed for all Non-
Privileged commands. When using remote configuration, help information is
displayed for all Top Level commands.
If you have forgotten the device's enable password, see Appliance
Factory Default Reset Password on page 77.
create
Appendix C Command Summary
flag to create the specified group and enter
form of the command remove the
no
form of the
on
all
Page 83
Advertisement
Table of Contents
