Table of Contents
Advertisement
Configuration Command Set
Use Configuration mode commands to configure the Ethernet interface and SSL functions
of the SSL device. Enter Configuration mode using the configure command in Privileged
mode.
Command:
[no] access-list <id> <permit | deny> <ipaddr> <mask>
Remote, Serial, Telnet
Availability:
Adds an access list entry to the end of the specified access list, where id is the list
Description:
identifier, ipaddr and mask are the IP address and mask to be added, respectively.
The mask is a filter, defining how IP addresses are compared to addresses in the
access list for access permission or denial. See the example below. You can have
up to four access lists for each device. Use the
access list. The
deny
you must also use the
command.
Example:
access-list 2 permit 100.1.2.3 0.0.0.0
Specifies the host with the IP address 10.1.2.3 to be the only remote host to
configure the remote device.
access-list 1 permit 100.128.0.0 0.0.255.255
Specifies only remote hosts on the identified subnet can configure the remote
device.
Caution: Configuring an access list automatically sets up an implied access denial.
For example, if you have set up an access list containing the IP addresses of remote
hosts allowed to access the appliance, all other IP addresses have access denied. If
you configure a single access list denying access from IP addresses in that list, all
other IP addresses are denied access as well.
Command:
end
Availability:
Remote, Serial, Telnet
Description:
Exits Configuration mode and returns to Privileged mode.
Command:
exit
Availability:
Remote, Serial, Telnet
Description:
Exits Configuration mode and returns to Privileged mode.
Command:
help [command]
Availability:
Remote, Serial, Telnet
Description:
Displays help information for the specified command, where command is the name
of the command. If not command is specified, help information is displayed for all
Configuration mode commands.
option allows access from the specified address(es). The
permit
option locks access from the specified address(es). To activate the access list,
remote-management access-list
Appendix C Command Summary
flag to delete the entire specified
no
or
snmp access-list
Page 101
Advertisement
Table of Contents
