Table of Contents
Advertisement
When you attempt to attach to the SSL appliance using the remote configuration manager,
this prompt is displayed:
myDevice requires secure communication.
Enter passphrase for myDevice:
Enter the passphrase set previously.
You can change the TCP/UDP service port to be used when communicating with the device
for management with the remote configuration manage. The TCP/UDP service port can be
configured using any of the configuration connection options. You must save the
configuration to flash and reboot for the port information to take effect.
(config[myDevice])# remote-management port 8089
(config[myDevice])# end
myDevice# write flash
myDevice# reload
When the remote configuration manager is started, or the basic discover command is
entered, the device is not found. You must enter the discover command using the TCP
service port as an argument. The following command tells the configuration manager to
use port 8089 to look for SonicWALL SSL appliances.
inxcfg> discover port 8089
The device is listed following a show device list command. Attach to the device configured
in this example using the following command:
inxcfg> attach ip 10.1.2.3 port 8089
If a passphrase has been configured for the device, you are prompted for it. Return the
device management TCP service port by entering this command in Configuration mode:
(config[myDevice])# remote-management port default
EXAMPLE: Configuring an Ethernet Interface
The Ethernet interfaces on the SSL appliance can be configured at either 10 Mbps or
100 Mbps and half or full duplex. Attach to the device (remote only) and enter Privileged
and Configuration modes. In the following example, the "Network" interface of myDevice
is forced to full duplex. Make sure to save this configuration to flash.
(config[myDevice])> interface network
(config-if[network])> duplex full
(config-if[network])> speed 100
(config-if[network])> end
(config[myDevice])> end
inxcfg>
Page 56 SSL-IA/SSL-R User's Guide
Advertisement
Table of Contents
