Table of Contents
Advertisement
8A3xxxx 72QFN Evaluation Kit Manual
5. In order to connect the board with Timing Commander (PC), click the button (red circle) at the up-right corner
of the GUI to set up the communication protocols (see
selected, click OK to close the window
6. Click on the chip symbol at the upper-right corner of the GUI window to initiate the connection. The connection
is valid when a green band appears at the upper-right corner of the window, as shown in
7. If ClockMatrix device's firmware, or firmware loaded from EEPROM, has a different version from that in the
Personality file, a firmware version mismatch warning message will appear (see
button to close the message window and a connection is made.
R31UH0015EU0101 Rev.1.01
Apr 26, 2022
(seeFigure
Figure 9. Setting I2C for Connecting the Board with GUI
Figure 10. A Green Band Appears when a Valid Connection is Made
Figure
8). After I2C and one-byte addressing are
9).
Figure
10.
Figure
11). Click "Close"
Page 9
Advertisement
Table of Contents
