M3028BT2-CPE User's Manual
3.3 MCU Setting Dialog Box
The MCU Setting dialog box is used to set the user system information. It is displayed after you closed the Init dialog box.
(1) MCU tab
1. Specifying the processor mode
2. Referring to the MCU Status
REJ10J1457-0300 Rev.3.00 July 22, 2009
3. Usage (How to Use the Emulator Debugger)
Specifying the processor mode
Select the appropriate processor mode that suits your
system. For this product, you can specify only the following
processor mode:
- Single-Chip Mode
Specifying the PM10 area (bit 0 of the
address 00005h)
Select this option when using the MCU in which the data
area access enable bit (PM10) is set to 1.
Referring to the MCU Status
It shows the pin status of the user system. Check it to see if
the MCU status matches the selected processor mode. If the
status of any pin is marked "NC", it means that the pin
status is indeterminate.
Page 48 of 90