Servo Installation - FUTABA 1M23N20718 Instruction Manual

Warning
Connector Connections
Be sure the receiver, servo, battery and connectors are fully and firmly connected.
If vibration from the model causes a connector to work loose while the model is in operation, you may lose control .

Servo Installation

When you install the servos, always use the rubber grommets provided in servo hardware bags.
Mount the servos so they do not directly come in contact with the mount.
If the servo case comes in direct contact with the mount, vibration will be directly transmitted to the servo.
If this condition continues for a long time, the servo may be damaged and control will be lost.
Screw
Damper
Eyelet
Mechanical plate
Nut (as required)
When installing the servo, always install the accessory
rubber grommet and grommet flush against the servo.
A vibration-damping effect is not obtained even
if the rubber grommet and grommet are not in-
stalled correctly.
Servo Throw
Operate each servo over its full stroke and be sure the linkage does not bind or is loose.
The continuous application of unreasonable force to a servo may cause damage and excessive battery drain.
Decide the EPA value at the
contact point.
Adjust the steering servo so that unreason-
able force is not applied to the servo by the
chassis at maximum servo travel.
(or)
Adjust the throttle servo so that unreasonable force is
not applied when the engine carburetor is fully open,
fully closed, and the brakes are applied fully.
If the brakes overheat while running, their ability to
function properly decreases. Before running, adjust the
suitable maximum servo travel so that unreasonable
force is not applied even when the servo travel is in-
creased while running.
33