Table of Contents
Advertisement
Engine Oil Specifications
Use Terex 10W-30 Heavy Duty Engine Oil for most
conditions (if available). In the event of an alternate
working environment, the following chart may be used
as a guide to oil viscosity grades (see below).
You may also use a quality engine oil substitute meet-
ing the following minimum specification:
• API CH-4 multigrade engine oil.
To check the oil level:
1. Park the PT-100 Forestry on level ground.
2. Open the hood to gain access to the engine com-
partment.
3. Locate and remove the engine oil dipstick (A) from
its tube.
4. Wipe the dipstick with a clean shop cloth and re-
insert it into the tube until it comes to rest in its
seated position.
5. Remove the dipstick once again and inspect the
end for oil on the level indicator.
6. Oil should be present on the dipstick up to, but not
over the upper (full) level indicator notch. If the
level is correct, reinstall the dipstick and then close
and latch the hood to complete the procedure.
7. If the level is low, add the proper grade and viscos-
ity engine oil and recheck as necessary until the
proper level has been achieved. Then reinstall the
dipstick and filler cap and close and latch the hood
to complete the procedure.
A
Low
11-25
C
11-26
11-13
Compact Track Loader
11. Maintenance
Full
B
Advertisement
Table of Contents
