Table of Contents
Advertisement
Compact Track Loader
11. Maintenance
Cab Filtration
The cab is equipped with two air filters, one on each
side of the cab enclosure. They should be inspected
daily and cleaned/replaced as necessary.
To clean:
1. Remove the thumb screws securing the side panel
to the cab AC unit, then remove the panel and
filter.
2. Inspect the filter for damage. If damaged, replace
filter. If not damaged, remove the filter and tap
gently along rigid edge of filter to clean. To reinstall
the filter, reverse step 1.
3. Repeat steps 1 and 2 on the opposite side of the
machine.
Note: Filters must be clean to maintain cab pressure.
Clean daily or as needed.
Fan Cleaning
The heater/AC unit is equipped with two fans that cir-
culate air through the unit. They must be cleaned daily
to ensure proper function.
To clean:
1. Remove the thumb screws securing the lower
portion of the fan guard to the rear of the
heater/AC unit.
2. Lift the guard from the bottom and pivot it upward
to expose the fans.
3. Following the guidelines on page 11-2, use com-
pressed air only to blow any dirt or debris clear of
the fans.
4. Reverse steps 1 and 2 to complete the procedure.
11-22
Advertisement
Table of Contents
