Table of Contents
Advertisement
Compact Track Loader
6. Chassis Disassembly and Assembly
Fuel drain
plug
Figure 6-1
2. Remove fuel/water separator to gain access to
the fuel sender. (fig. 6-2)
Remove fuel/water
separator
Figure 6-2
Sending Unit
Wires
Figure 6-3
3. Disconnect the wires to the fuel sending unit
on the right side tank. (fig. 6-3)
Note: If the fuel sending unit wires are crossed, the fuel
gauge will not work.
Figure 6-4
4. Remove the fuel sending unit. Be careful not
to damage the float mechanism when pulling it
through the opening in the fuel tank. (fig. 6-4)
Fuel Sending Unit Installation
1. To install sending unit, reverse the removal
procedure.
Fuel Tank Removal
The PT-100 Forestry has two fuel tanks that are
connected by a cross over tube, the procedure is
basically the same for each tank.
1. Drain the fuel tanks. (fig. 6-1)
2. With the engine cold, remove the exhaust pipe,
and loosen the muffler. The muffler does not need
to be removed, but having it loose will enable access
to some fuel tank mounting bolts. (fig. 6-5)
6-2
Advertisement
Table of Contents
