Engine Oil Check - Terex PT60CE Operation And Maintenance Manual

7 MAINTENANCE

7.5 Engine Oil Check

1. Shut the machine down according
to the procedure in section 5.13.
2. Open the hood to gain access to the
engine compartment.
3. Locate and remove the engine oil
dipstick (1) from its tube. (fig. 7.5-1)
4. Wipe the dipstick with a clean
shop cloth and reinsert it into the
tube until it comes to rest in its
seated position.
5. Remove the dipstick once again and
inspect the end for oil on the level
indicator.
6. Oil should be present on the dipstick up to, but not over the upper (full) level
indicator notch. If the level is correct, reinstall the dipstick and then close
and latch the hood to complete the procedure. (fig. 7.5-2)
7. If the level is low, add the proper grade and viscosity engine oil and re-
check as necessary until the proper level has been achieved. Then re-install
the dipstick and filler cap and close and latch the hood to complete the
procedure.
7.5-1
Full
7.5-2
68
1
Low