Table of Contents
Advertisement
Compact Track Loader
5. Operator Enclosure Disassembly and Assembly
4. Install the gauge panel. Refer to Chapter 5.
Gauge Panel Installation procedure.
Gauge Removal and Installa-
tion
The tools required for gauge removal and installation
are listed in Table 5-3. Use manufacturer-
recommended tools whenever possible.
Table 5-3
Required Tools
Combination wrench / nut driver
Gauge Removal
1. Lower the gauge panel. Refer to Chapter 5.
Gauge Panel Removal procedure.
Figure 5-13
2. Disconnect the connector from the gauge.
Figure 5-14
3. Remove the two nuts that secure the gauge to
the retaining bracket.
Figure 5-15
4. Pull the gauge out from the front of the dash
panel.
Gauge Installation
Figure 5-16
1. Insert the gauge from the front of the dash
panel.
Figure 5-17
2. Install the two nuts that secure the gauge to the
retaining bracket.
5-4
Advertisement
Table of Contents
