Table of Contents
Advertisement
Figure 5-18
3. Reconnect the gauge connector.
4. Install the gauge panel. Refer to Chapter 5.
Gauge Panel Installation procedure.
Head Light Removal and In-
stallation
The tools required for head light removal and instal-
lation are listed in Table 5-4. Use manufacturer-
recommended tools whenever possible.
Table 5-4
Required Tools
Torx Screwdriver
Head light Removal
Figure 5-19
1. Remove the four fasteners that secure light cov-
er in place. (When removing cover take care
not to lose the spacers from between cab and
cover.)
5. Operator Enclosure Disassembly and Assembly
Figure 5-20
2. To remove light, push the light inward and re-
move grommet. Then reach through opening
and pull light out.
Figure 5-21
3. Disconnect head light from harness.
Head Light Installation
Figure 5-22
1. Reconnect head light to harness.
5-5
Compact Track Loader
Advertisement
Table of Contents
