CyberData 011414 Operation Manual page 59

2. On the Multicast page, enter values for the parameters indicated in
Note
Web Page Item
Enable Multicast Operation
Priority
Address
Port
Name
Buffer
Beep
Relay
Note
Note
Note
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-15. Multicast Page Parameters
Description
Enables or disables multicast operation.
Indicates the priority for the multicast group. Priority 9 is the highest (emergency
streams). 0 is the lowest (background music). SIP calls are considered priority 4.5.
See Section 2.4.10.1, "Assigning Priority"
Enter the multicast IP Address for this multicast group (15 character limit).
Enter the port number for this multicast group (5 character limit [range can be from
2000 to 65535]).
Note: The multicast ports have to be even values. The webpage will enforce this
restriction.
Assign a descriptive name for this multicast group (25 character limit).
Device will buffer up to four minutes of audio and then play back the recording after
the multicast stream finishes or after the buffer is full.
When selected, the device will play a beep before multicast audio is sent.
When selected, the device will activate a relay before multicast audio is sent.
Use this button to preview the strobe flashing behavior for the Multicast Strobe
Settings.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of the web
page items. First click on the Toggle Help button, and you will see a question mark
( ) appear next to some of the web page items. Move the mouse pointer to hover
over a question mark to see a short description of a specific web page item.
You must click on the Save button for the changes to take effect.
Changing the Enable Multicast
reboot for the changes to take effect.
Enabling or disabling the strobe or changing any of the strobe options require you to click on
the Save button for the changes to take effect.
931338B
Installing the SIP-enabled h.264 Video Outdoor Intercom with Keypad
) in the following table shows which web page items will be defined
.
Operation, Address, Beep, or
Configure the Intercom Parameters
Table 2-15.
for more details.
Relay settings require a
CyberData Corporation
52