CyberData 011414 Operation Manual page 64

Web Page Item
Play recorded audio
Repeat Intrusion Message
Note
Note
Operations Guide
Table 2-16. Sensor Configuration Parameters (continued)
Description
When selected, the device will call the Dial Out Extension and play an audio file
(corresponds to Intrusion Sensor Triggered on the Audiofiles page) to the
phone answering the SIP call when the intrusion sensor is activated.
The number of times to repeat the audio message through the local speaker or
to the remote endpoint. A value of 0 will repeat forever. Enter a value from 0-
65536.
Use this button to preview the strobe flashing behavior for the Intrusion Sensor
Strobe Settings.
Click the Test Door Sensor button to test the door sensor.
Click the Test Intrusion Sensor button to test the Intrusion sensor.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of the web
page items. First click on the Toggle Help button, and you will see a question
mark ( ) appear next to some of the web page items. Move the mouse pointer
to hover over a question mark to see a short description of a specific web page
item.
You must click on the Save button for the changes to take effect.
None of the Sensor Configuration Page
effect.
931338B
Installing the SIP-enabled h.264 Video Outdoor Intercom with Keypad
settings require a reboot for the changes to take
Configure the Intercom Parameters
CyberData Corporation
57