Replacing The Aerial (Rotor Sensor) - Hermle Z 326 Service Instruction

7 SERVICE INSTRUCTIONS

7.4.9 Replacing the aerial (rotor sensor)

• Remove the motor rubber covering by pulling it out simply.
• Remove the screws of the aerial.
loosen
• Remove the lower covering of the front housing as described in chapter 7.4.1.
• Remove the connection cable on the control board and remove the aerial.
1
• Put in the new aerial.
• Re-assemble the unit in reverse order.
Page 31 of 48 SERVICE INSTRUCTION Z 326 © HERMLE Labortechnik GmbH
Version 01/2010