Replacing The Incremental Shaft Encoder; Replacing The Display - Hermle Z 326 Service Instruction

7.4.2 Replacing the incremental shaft encoder

• Remove the cap on top of the incremental shaft encoder.
• With a socket wrench you can loosen the fastening nut, now.
• Loosen all electrical contacts to the shaft encoder on the back of the front housing.

7.4.3 Replacing the display

• Loosen all electrical contacts to the display on the back of the front housing.
• Remove the 4 fastening screws of the display and pull away the display upwards.
Page 27 of 48
remove
SERVICE INSTRUCTION Z 326
7 SERVICE INSTRUCTIONS
© HERMLE Labortechnik GmbH
Version 01/2010