Operation; Mounting And Loading The Angle Rotor; Installation Of Rotors - Hermle ZK 496 User Manual

OPERATION

2. OPERATION

2.1 Mounting and Loading the Angle Rotor

2.1.1 Installation of Rotors

Clean the drive shaft and the collet with a clean, grease-free piece of cloth. Place the rotor onto the
drive shaft (see Figure 13). Please be sure that the rotor is fully installed onto the motor shaft.
Figure 12 Figure 13
Hold the rotor with one hand and secure the rotor to the shaft by turning the fixing nut clockwise.
Tighten the fixing nut with the provided Allen key (see Figure 13).
Figure 14: fixing nut
ATTENTION: For safety always ensure that the rotor fixing screw is tightened before each run
(see Figure 13)
19
© Hermle Labortechnik GmbH ZK496_V1.22_eng