Hermle Z 326 Service Instruction page 3

7.4 Mounting support
7.4.1 Replacing the front housing
7.4.2 Replacing the incremental shaft encoder
7.4.3 Replacing the display
7.4.4 Replacing the foil keyboard
7.4.5 Removing the housing
7.4.6 Replacing the lid gasket
7.4.7 Replacing the lid
7.4.8 Replacing the hinges
7.4.9 Replacing the aerial (rotor sensor)
7.4.10 Replacing the motor resp. the motor bearings
7.4.11 Replacing the power board
7.4.12 Replacing the frequency converter
7.4.13 Checking and replacing the imbalance sensor
7.4.14 Replacing the control panel
7.4.15 Replacing the braking resistance
7.4.16 Replacing the signal generator
7.4.17 Replacing the lid lock
8 TROUBLE SHOOTING
8.1 Error messages: Cause / Solution
8.2 Survey of possible error messages and their solutions
8.2.1 Lid release during power failure
8.2.2 Description of the error message system
8.2.3 Error messages
9 MAINTENANCE
9.1 Service and maintenance
9.1.1 Maintenance and cleaning
9.1.2 Glass breakage
9.1.3 Disinfection
10 CIRCUIT DIAGRAMS
10.1 Flow diagrams
10.1.1 Flow diagram 230 V / 120 V / 50-60 Hz; Page 1
10.1.1 Flow diagram 230 V / 120 V / 50-60 Hz; Page 2
11 SPARE PART LIST
Technical modification rights reserved.
© HERMLE Labortechnik GmbH 2010 / 01
Page 3 of 48 SERVICE INSTRUCTION Z 326
CONTENT
© HERMLE Labortechnik GmbH
Version 01/2010