Submenu Motor Starts; Submenu Duty Cycle - Hermle Z 326 Service Instruction

Now you have entered the Service mode. By pressing the key accel/decel you go to the submenus.
Now in the display „accel/decel" the word „service" will flash. Only as long as this word is flashing, you
can scroll through the further submenus with the potentiometer.
You have to repeat this step constantly to enter the different submenus.

7.3.1.1 Submenu Motor starts:

Here you can read off the number of motor starts.
• Activate the operation menu as described in chapter 7.3.1.
• Turn the potentiometer until the special digit „service A" appears in the display „acc/dec".
In the display „rpm/rcf" the number of motor starts is indicated now.

7.3.1.2 Submenu Duty cycle:

Here you can read off the duty cycle of the unit.
• Activate the operation menu as described in chapter 7.3.1.
• Turn the potentiometer until the special digit „service H" appears in the display „acc/dec".
In the display „rpm/rcf" the duty cycle is indicated now.
Page 12 of 48 SERVICE INSTRUCTION Z 326
7 SERVICE INSTRUCTIONS
© HERMLE Labortechnik GmbH
Version 01/2010