Basic Adjustment; Adjustment Of The Rotor Type; Access To The Mode: "Standard Settings - Hermle Z 167 M Operating Manual

Table of Contents

PRODUCT DESCRIPTION

1.8 Basic Adjustment

For centrifuge Z 167 M, only one rotor (220.95 V08) is acceptable. Due to this, rotor adjustments

cannot be conducted.

While starting this model, the following basic settings can be performed:

The following operating data can be retrieved in this menu:

Open the centrifuge lid and shut off the main switch. Now switch on again the main switch.For

approximately 3 seconds "Soft" will be shown in the display. Press during this time the keys "time"

(6) and "lid" (10) simultaneously. As a result, a display test is administered for approx. 3 seconds. All

possible indications will appear at the same time (see Figure 1). The LED light is flashing alternately

with green and red color.

Figure 1

ATTENTION:

The normal program mode can be changed back again by switching off the centrifuge,

for a short period!

All changed settings must be confirmed by the key, "start" (9). A confirmation screen

will appear with the word, "store", in the display "rpm/rcf" (A-1) - Only then the pre-

selections are valid!

Signal Turn On / Off

Keybord Sound On / Off

Sleep Mode On / Off

Number of Starts

Operating Hours of Centrifuge

Operating Hours of Motor

Software Version

Error List

Function of the Imbalance Switch

Operation of Keyboard

Hardware Version

Intermediate Circuit Voltage in Volt

Display Tests

Z167M_V1.18_eng

Table of Contents