Table Of Contents - Hermle Z 326 Service Instruction

6 TECHNICAL DATA
6.1 Acceleration times
6.2 Deceleration times
6.3 Imbalance shut off data
7 SERVICE INSTRUCTIONS
7.1 General technical description
7.2 Electrical and electronical components
7.2.1 Power board
7.2.2 Control board
7.2.3 Control panel
7.2.4 Frequency converter
7.2.5 Rotor recognition
7.2.6 Over speed protection
7.2.7 Speed signal
7.2.8 Lid contact
7.2.9 Imbalance detection
7.3 Operation menu
7.3.1 Activation of the Operation menu (Part 1)
7.3.1.1 Submenu Motor starts
7.3.1.2 Submenu Duty cycle
7.3.1.3 Submenu Running time of the motor
7.3.1.4 Submenu Software status
7.3.1.5 Submenu Software status of the frequency converter
7.3.1.6 Submenu Error memory
7.3.1.7 Submenu Setup of the temperature
7.3.1.8 Submenu Setup of the signal generator
7.3.1.9 Submenu Setup of the keypad tone
7.3.1.10 Submenu Setup Volume of the signal generator
7.3.1.11 Submenu Setup of the signal melody
7.3.1.12 Submenu Check and calibration of the imbalance sensor
7.3.1.13 Submenu Indication of the imbalance value of the rotor
7.3.1.14 Submenu Keyboard test
7.3.1.15 Submenu Indication of the revision number of the control panel;
Check of the external imbalance sensor
7.3.2 Activation of the Service menu (Part 2)
7.3.2.1 Adjustment of the centrifuge type
7.3.2.2 Adjustment of the operation mode
7.3.2.3 Submenu Adjustment/Correction of the imbalance cut off value
7.3.2.4 Submenu Activating/Deactivating of the electronical Imbalance
Page 2 of 48 SERVICE INSTRUCTION Z 326
CONTENT
© HERMLE Labortechnik GmbH
Version 01/2010