Operation; Mounting And Loading The Angle Rotor; Installation Of Rotors - Hermle Z 366 K User Manual

OPERATION

2. OPERATION

2.1 Mounting and Loading the Angle Rotor

2.1.1 Installation of Rotors

Clean the drive shaft and the collet with a clean, grease-free piece of cloth. Place the rotor onto the
drive shaft, (see Figure 10). Please be sure that the rotor is fully installed onto the motor shaft.
Figure 10 Figure 11
Hold the rotor with one hand and secure the rotor to the shaft, by turning the fixing nut clockwise.
Tighten the fixing nut with the provided Allen key, (see Figure 11).
Figure 12
ATTENTION: For safety, always ensure that the rotor fixing screw is tightened before
each run, (see Figure 11)!!
© Hermle Labortechnik GmbH Z366K_V1.22_eng 17