Operation; Mounting And Loading The Angle Rotor; Installation Of Rotors; Loading Angle Rotors - Hermle Z 307 User Manual

Table of Contents

2. OPERATION

Clean the drive shaft and the connection surface of the rotor with a clean, grease-free piece of cloth.

Place the rotor onto the drive shaft, (see Figure 14). Please be sure that the rotor is fully installed onto

the motor shaft.

Figure 14

Hold the rotor with one hand and secure the rotor to the shaft, by turning the fixing nut clockwise.

Tighten the fixing nut with the provided Allen key, (see Figure 15 and Figure 16).

Figure 16

ATTENTION: For safety, always ensure that the rotor fixing screw is tightened before each run

(see Figure 15).

Rotors must be loaded symmetrically and with equal weight, (see Figure 17 and 18). The adapter may

only be loaded with the appropriate vessels. The weight differences between the filled vessels should

be kept as low as possible. Therefore, we recommend to weigh with a balance. This reduces the wear

of drive and the acoustic operating noise.

Each rotor indicates what the maximum capacity is per hole.

Figure 15

Z307_V1.22_eng

OPERATION

Table of Contents

Show Quick Links

Table of Contents