Submenu Setup Of The Keypad Tone - Hermle Z 326 Service Instruction

• Now the audible sound is activated resp. not activated by the end of the run or when an error
message will occur.
Attention: In case that the signal generator is switch off, the keypad tone and the audible error
message will also be suppressed.
The keypad tone has to be switched on again after the reactivation of the signal generator.
However the audible error message is automatically activated if the signal generator has been
reactivated.
Attention: After all points have been reviewed and/or set up, you have to press shortly the key
start to store all parameters. Otherwise the setups were all for nothing. If the storage has been
successful in the display „rpm/rcf" the value of the imbalance sensor and the word „StorE" are
indicated.

7.3.1.9 Submenu Setup of the keypad tone:

Here you can switch on resp. switch off the keypad tone.
• Activate the operation menu as described in chapter 7.3.1.
• Turn the potentiometer until the special digit „service b" appears in the display „acc/dec".
• By pressing the key rpm/rcf the display „rpm/rcf" is now activated and you can setup the
respective option with the potentiometer.
• Now the keypad tone is either activated or not activated.
Attention: In case that the signal generator is switch off, the keypad tone and the audible error
message will also be suppressed.
The keypad tone has to be switched on again after the reactivation of the signal generator.
However the audible error message is automatically activated if the signal generator has been
reactivated.
Page 17 of 48 SERVICE INSTRUCTION Z 326
7 SERVICE INSTRUCTIONS
© HERMLE Labortechnik GmbH
Version 01/2010