Dc 4-Wire; Measurement Display Modes (Pel 103) - AEMC PEL102 User Manual

3.6.6.3 Dc 4-Wire

For DC 4-Wire measurements and using three current sensors:
■
Connect the terminal N test lead to the common conductor
■
Connect the terminal V1 test lead to conductor +1
■
Connect the terminal V2 test lead to conductor +2
■
Connect the terminal V3 test lead to conductor +3
■
Connect the terminal I1 current probe to conductor +1
■
Connect the terminal I2 current probe to conductor +2
■
Connect the terminal I3 current probe to conductor +3
Ensure that the current arrow on the sensor is directed towards the
load. This ensures proper measurements for power and other sign
sensitive quantities.

3.7 Measurement Display Modes (PEL 103)

This section provides display screen examples for each measurement mode. With the PEL, the user can scan through vari-
ous measurement values and set-up parameters. The ◄ and ► navigation buttons are used to scroll through the available
modes.
The Five Measurement Modes are:
■
Measurement Values: V, A, Power, Frequency , Power Factor, Tangent Angle -
press
■
Energy Values: kWk, Vah, Varh -
press
■
Harmonics (for Current and Voltage) -
press
■
Min/Max Vales for Measurement, Energy and Harmonic values -
press
■
Information on Hook-up selection, PT and CT ratios, IP Address, Software Version and Serial No. -
NOTE: The PEL can only be configured through the PEL Control Panel (DataView
For detailed instructions on configuring, recording and downloading measurements, refer to § 4.
The NAVIGATION
ment Modes.
Power & Energy Logger Model PEL 102 and PEL 103
Find Quality Products Online at:
and ENTER buttons are used to scroll and move through the selected Displayed Measure-
GlobalTestSupply
www.
V1 V2 V3 N I1 I2
Figure 28
software) prior to use.
®
.com
sales@GlobalTestSupply.com
+1
+2
+3
_
I3
29