Vacon 100 hvac Applications Manual page 93

PARAMETERS MENU
Table 33: Setpoint settings
Index Parameter
P3.12.2.8
Sleep Delay 1
P3.12.2.9
Wake-up Level 1
Setpoint 1 Wake-up
P3.12.2.10
Mode
P3.12.2.11 Setpoint 1 boost
Setpoint source 2
P3.12.2.12
selection
P3.12.2.13 Setpoint 2 minimum
P3.12.2.14 Setpoint 2 maximum
Sleep Frequency
P3.12.2.15
limit 2
P3.12.2.16 Sleep Delay 2
P3.12.2.17 Wake-up Level 2
Setpoint 2 Wake-up
P3.12.2.18
mode
P3.12.2.19 Setpoint 2 boost
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
Min Max Unit
0 3000 s
0.01 100 x
0 1
-2.0 2.0 x
0 16
-200.00 200.00 %
-200.00 200.00 %
0.00 320.00 Hz
0 3000 s
Varies
0 1
-2.0 2.0 x
Default ID Description
The minimum quantity of
time during which the
0 1017 frequency has to stay
below the sleep level
before the drive stops.
If the PID controller is in
sleep mode, it starts the
drive and regulates
when it goes below this
0 1018
level. Absolute level or
relative to the setpoint
based on WakeUpMode
parameter.
The selection for the
operation of P3.12.2.9.
0 15539
0 = Absolute level
1 = Relative setpoint
It is possible to boost the
1.0 1071 setpoint with a digital
input.
See P3.12.2.4.
2 431
The minimum value at
0.00 1073 the analogue signal min-
imum.
The maximum value at
100.00 1074 the analogue signal
maximum.
See P3.12.2.7.
0.00 1075
0 1076 See P3.12.2.8.
0.0000 1077 See P3.12.2.8.
The selection for the
operation of P3.12.2.17.
0 15540
0 = Absolute level
1 = Relative setpoint
1.0 1078 See P3.12.2.11.
VACON · 93
5