Vacon 100 hvac Applications Manual page 47

MONITORING MENU
Table 3: Items in the monitoring menu
Index Monitoring value
V2.2.1 Output frequency
V2.2.2 Frequency reference
V2.2.3 Motor speed
V2.2.4 Motor current
V2.2.5 Motor torque
V2.2.7 Motor shaft power
V2.2.8 Motor shaft power
V2.2.9 Motor voltage
V2.2.10 DC link voltage
V2.2.11 Unit temperature
V2.2.12 Motor temperature
V2.2.13 Analogue input 1
V2.2.14 Analogue input 2
V2.2.15 Analogue output 1
V2.2.16 Motor Preheat
V2.2.17 Drive Status Word
V2.2.19 Fire mode status
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
Unit ID
Hz 1 The output frequency to motor
Hz 25 The frequency reference to motor control
rpm 2 The actual speed of the motor in rpm
A 3 Motor current
% 4 The calculated shaft torque
% 5 The calculated motor shaft power in percentage
The calculated motor shaft power in kW or hp. The
kW/hp 73
unit is set in the unit selection parameter.
V 6 The output voltage to motor
V 7 The measured voltage in the DC-link of the drive
°C 8 The heatsink temperature in Celsius or Fahrenheit
The calculated motor temperature in percentage
% 9
of the nominal working temperature
% 59 The signal in percentage of the used range.
% 60 The signal in percentage of the used range.
% 81 The signal in percentage of the used range.
The status of the Motor preheat function
1228
0 = OFF
1 = Heating (feeding DC-current)
The bit coded status of the AC drive.
B1 = Ready
B2 = Run
B3 = Fault
43
B6 = RunEnable
B7 = AlarmActive
B10 = DC Current in stop
B11 = DC Brake Active
B12 = RunRequest
B13 = MotorRegulatorActive
0 = Disabled
1597 1 = Enabled
2 = Activated
3 = Test mode
VACON · 47
Description
4