Vacon 100 hvac Applications Manual page 92

VACON · 92
Table 33: Setpoint settings
Index Parameter
P3.12.2.1 Keypad setpoint 1
P3.12.2.2 Keypad setpoint 2
P3.12.2.3 Setpoint ramp time
Setpoint source 1
P3.12.2.4
selection
P3.12.2.5 Setpoint 1 minimum
P3.12.2.6 Setpoint 1 maximum
P3.12.2.7
Sleep Frequency
limit 1
5
Min Max Unit
Varies Varies Varies
Varies Varies Varies
0.00 300.0 s
0 16
-200.00 200.00 %
-200.00 200.00 %
0.00 320.00 Hz
PARAMETERS MENU
Default ID Description
0 167
0 168
Gives the rising and fall-
ing ramp times for the
setpoint changes. That
0.00 1068
is, the time to change
from the minimum to
the maximum.
0 = Not used
1 = Keypad setpoint 1
2 = Keypad setpoint 2
3 = AI1
4 = AI2
5 = AI3
6 = AI4
7 = AI5
8 = AI6
9 = ProcessDataIn1
10 = ProcessDataIn2
11 = ProcessDataIn3
12 = ProcessDataIn4
1 332
13 = ProcessDataIn5
14 = ProcessDataIn6
15 = ProcessDataIn7
16 = ProcessDataIn8
AI's and ProcessDataIn
are handled as percen-
tages (0.00- 100.00%)
and scaled according to
the setpoint minimum
and maximum.
ProcessDataIn signals
use two decimals.
The minimum value at
0.00 1069 the analogue signal min-
imum.
The maximum value at
100.00 1070 the analogue signal
maximum.
The drive goes to sleep
mode when the output
frequency stays below
0.00 1016
this limit for a longer
time than set by Sleep
Delay.
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205