Vacon 100 hvac Applications Manual page 68

VACON · 68
Table 14: Digital input settings
Index Parameter
P3.5.1.14 Motor Preheat ON
P3.5.1.15
Preset Frequency Selection 0
P3.5.1.16
Preset Frequency Selection 1
P3.5.1.17
Preset Frequency Selection 2
P3.5.1.18 Timer 1
P3.5.1.19 Timer 2
P3.5.1.20 Timer 3
P3.5.1.21 Disable Timer Function
P3.5.1.22 PID1 Setpoint Boost
P3.5.1.23 PID1 Select Setpoint
P3.5.1.24 PID2 Start Signal
5
Default ID
DigIN Slot0.1 1044
DigIN SlotA.4 419
DigIN SlotA.5 420
DigIN Slot0.1 421
DigIN Slot0.1 447
DigIN Slot0.1 448
DigIN Slot0.1 449
DigIN Slot0.1 1499
DigIN Slot0.1 1047
DigIN Slot0.1 1046
DigIN Slot0.2 1049
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
PARAMETERS MENU
Description
OPEN = No action.
CLOSED = Uses the DC current of the
motor preheat in Stop state. Used
when the value of P3.1.2.5 is 2.
A binary selector for preset speeds
(0-7). See Table 12 Control reference
settings.
A binary selector for preset speeds
(0-7). See 5.3 Group 3.3: Control refer-
ence settings.
A binary selector for preset speeds
(0-7). See Table 12 Control reference
settings.
The rising edge starts Timer 1 that
was programmed in Group 3.11:
Timer functions.
See above.
See above.
This digital input signal controls all
timer functions (for example, Inter-
vals 1-5 and Timers 1-3).
CLOSED = Disables the Timer func-
tions and resets timers.
OPEN = Enables the Timer functions.
OPEN = No boost
CLOSED = Boost
OPEN = Setpoint 1
CLOSED = Setpoint 2
OPEN = PID2 in stop mode
CLOSED = PID2 regulating
This parameter has no effect if the
PID2 controller is not enabled in the
Basic menu for PID2