Edge-Core ECS4620-28T Quick Start Manual page 1294

28/52-port l3 stackable gigabit ethernet switch
Hide thumbs Also See for ECS4620-28T:
Table of Contents

Advertisement

Chapter 14
| Port Mirroring Commands
Local Port Mirroring Commands
vlan-id - VLAN ID (Range: 1-4094)
mac-address - MAC address in the form of xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxx.
acl-name – Name of the ACL. (Maximum length: 16 characters, no spaces or
other special characters)
Default Setting
No mirror session is defined.
When enabled for an interface, default mirroring is for both received and
transmitted packets.
When enabled for a VLAN or a MAC address, mirroring is restricted to received
packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Command Usage
You can mirror traffic from any source port to a destination port for real-time
analysis. You can then attach a logic analyzer or RMON probe to the destination
port and study the traffic crossing the source port in a completely unobtrusive
manner.
Set the destination port by specifying an Ethernet interface with the
configuration command, and then use the
the source of the traffic to mirror.
All VLAN mirror sessions must share the same target port, preferably one that is
not a member of the source VLAN.
When mirroring traffic from a port, the mirror port and monitor port speeds
should match, otherwise traffic may be dropped from the monitor port. When
mirroring traffic from a VLAN, traffic may also be dropped under heavy loads.
When VLAN mirroring and port mirroring are both enabled, the target port can
receive a mirrored packet twice; once from the source mirror port and again
from the source mirror VLAN.
When mirroring traffic from a MAC address, ingress traffic with the specified
source address entering any port in the switch, other than the target port, will
be mirrored to the destination port.
Spanning Tree BPDU packets are not mirrored to the target port.
When mirroring VLAN traffic or packets based on a source MAC address, the
target port cannot be set to the same target port as that used for basic port
mirroring.
port monitor
– 464 –
interface
command to specify

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents